Purpose:
To deep clean embedded soil and preserve an attractive carpet.

Required Supplies and Equipment:
• Carpet Extraction Machine
• Air Mover Machine
• Carpet Extractor Shampoo
• Defoamer
• Traffic Lane Spotting Solution
• Carpet Deodorizer Concentrate
• Measuring Cup
• Empty/Refill Bucket
• Clean Rags and Wipers

1. Preparation
   Remove all obstructions from the area to be cleaned. If possible, remove the furniture. Vacuum the area prior to cleaning with an extractor. Assemble all the equipment and supplies and take them to the area to be cleaned. Fill solution tanks or portable buckets and add the properly measured extraction solution to the water.
   
2. Carpet Extraction Procedure
   Move carpet extractor machine to area to be cleaned.
   Place the vacuum tool on the carpet.
   
   Turn the pump/sprayer and vacuum switches to the “on” position.
   
   Move the machine at a gradual, steady pace. Be sure that the pickup tool is moving while the pump and sprayer are on.
   When you have made a complete pass over the area to be cleaned, turn off the pump/sprayer. Continue to pick up with the vacuum shoe until you have extracted the area between the sprayer nozzles and the vacuum shoe (this space varies from machine to machine).
   
   Repeat this procedure on the next section of carpet. Be sure to overlap 2 or 3 inches on each pass.
   
   When the area is clean, allow the carpet to dry before replacing furniture. Wet carpet can cause rust and indentations from furniture. Air Mover Machines speed drying times up considerably. Also foil or cardboard squares may be used under the legs of furniture if the room must be put back into service before the carpet is dry.
   
3. Clean Up
   Empty all unclean solution from the extractor tanks. Thoroughly flush out and rinse both tanks. Wash recovery tanks until there is no soil residue remaining inside. Wipe with a clean, lint free wiper. Repeat this procedure in the clean solution tank. Run clean solution through all vacuum hoses before transporting them to other areas. Thoroughly wash and wipe all domes and lids. Clean the outside of the machine before transporting to other areas. Wash and wipe the vacuum shoe and spray nozzle area. Remove the dirt, fuzz and lint before the machine is moved to other areas.